5/29/2023 0 Comments Displaycal profile type retina2020 or DCI P3) as madVR will overwrite the metadata depending on the 3D LUT install slot. madVR 3D LUT installation: Don't attempt to install 3D LUTs with unsupported input primaries metadata (i.e.madVR 3D LUT generation: Always write D65 white to 3D LUT input primaries metadata so madVR does not attempt to correct whitepoint differences on its own when using a custom whitepoint (the 3D LUT itself will map the custom whitepoint correctly).Profile loader (Windows): Use a minimally faster method to check for other running applications.macOS: Warn if a black luminance calibration target is set.Don't auto-close madTPG after 3D LUT installation.Only auto-close profile/3D LUT installation dialog after a successful installation.Increase automatic PCS to device table resolution for L*a*b* LUT profiles to 45x45x45 if using smoothing.Use a slightly improved smoothing method when creating high resolution PCS to device tables.When prompting for instrument calibration, display the just now detected instrument name instead of the previously enumerated name (the latter might be stale if you forgot to refresh after changing connected instruments).Always enumerate instruments on application startup if more than one instrument was detected the last time the application was used (cross-platform consistency).Move them to the trash automatically if they were previously (manually) installed. Detect and warn about malformed colorimeter corrections (e.g.Linux: Work-around failure to launch if wxPython 3.0 / wxWidgets 3.0 release number do not match (using wxPython 3.0 is deprecated).Linux: Failure to launch with pre-release versions of wxPython 4.Do not re-use logfiles for standalone tools as long as other instances are still running.Prevent potential double prompt for instrument calibration.When loading settings from a profile, restore unused CIECAM02 viewing conditions (if applicable).Reload current calibration when cancelling profile installation (regression of a change to profile installation dialog handling in Displa圜AL 3.8.8, SVN revision r6252).Rename “LG OLED” (.dcl) 3D LUT format to “DeviceControl” and unlock available resolutions.Tone response curve plot now uses the illuminant-relative profile whitepoint instead of D50 for input values if using absolute colorimetric intent.Profile loader (Windows): Use an alternate method to enforce single instance if local IPC is blocked.Warn during automatic output levels detection if the display device input range or graphics driver output range look to be misconfigured.Adjust perceptual device to PCS table black point to match perceptual PCS to device table.Check SpyderX dark offset calibration and abort if it is too high (user error).Show the instrument serial number (if available) when prompting to physically interact with the instrument.Fix SpyderX calibration issue when using 32-bit ArgyllCMS executables.When using a custom profiling testchart with very few or no dark RGB gray patches, try to better maintain slope of existing points during shaper curve generation.When previous instance was force quit, override leftover lockfile.Improve PCS to device gamut outline plot.
0 Comments
Leave a Reply. |